I’ve never tried it, but as long as your vinyl has a design on it that can be photographed, I can’t see why not.

Me too, did you get an answer for this?

Hi Peter,

Have you tried contacting Silhouette? They should be able to answer your questions for you.

Hi, does anyone have an answer for this? I have the same issue. I have my image in the PixScan Design view and it is ready to cut. In my Design Page Settings, the Cutting Mat selections do not include the PixScan Mat. If I try to send the image to be cut without setting the mat, I get a registration error on the machine display.

I’m so sorry they aren’t being helpful. I wish I could figure out what the problem might be.

No, my mat is super sticky and the paper doesn’t move at all… It’s a bummer because it’s unusable at this point if it doesn’t cut where it should. I’ve contacted Silhouette, but they haven’t responded other than to say to calibrate my phone–which I did before I contacted them. 🙁

I’m not sure. Is the paper moving slightly while it is cutting? Maybe the mat isn’t sticky enough anymore?